LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1619 (Automatic Transmission - 4T45-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Transmission Fluid Cooler Pipe Fitting Seal Installation >> Installation

Transmission Fluid Cooler Pipe Fitting Seal Installation: Installation

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying J 41239-1
    GM55139Courtesy of GENERAL MOTORS CORP.
    CAUTION: Failure to lubricate the cooler line seals with automatic transmission fluid DEXRON ® Vl before installing into the case or before installing the cooler line pipes into the seals may cause damage to the seal.
  1. Lubricate the inside surface of both cooler line seals (49) with automatic transmission fluid DEXRON ® V1.
  2. Place a new cooler line seal (49) in the case bore.
  3. Install the J 41239-1A:  seal installer on the transmission case (51) at the cooler line bracket bolt hole.
  4. Press the new cooler line seal (49) in by tightening the seal pressing bolt on the J 41239-1A:  seal installer until the seal bottoms out in the case bore.
  5. Repeat steps 2-4 for the second cooler line seal (49).
scientia non olet · About LEMON Manuals