Drive Sprocket Support Assemble

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 23327: Clutch Spring Compressor
J 41232: Return Spring Compressor

For equivalent regional tools, refer to Special Tools .

Fig 1: Identifying 2nd Clutch Piston And Seal Assembly

Courtesy of GENERAL MOTORS CORP.

In order to aid in the assembly, lubricate the seal with transmission fluid.
Assemble the 2nd clutch piston and seal assembly (404) into the driven sprocket support (401).
Assemble the 2nd clutch spring and retainer assembly (405) into the driven sprocket support.

Fig 2: View Of 2nd Clutch Spring Retainer Snap Ring

Courtesy of GENERAL MOTORS CORP.

Compress the 2nd clutch spring assembly. Use the J 41232: spring compressor and J 23327: spring compressor or equivalent.
Assemble the 2nd clutch spring retainer snap ring (406).
Remove the J 41232: spring compressor and J 23327: spring compressor.

Fig 3: Locating Seal Rings On Driven Sprocket Support

Courtesy of GENERAL MOTORS CORP.

Assemble two new seal rings (403) onto the driven sprocket support.