Roof Panel Joint Finish Molding Replacement (w/o V59)

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Roof Panel Joint Finish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Roof Panel Exterior Molding Procedure Remove the roof panel exterior molding starting at the rear of the vehicle. Release the six molding retainers from the body panel. Upon installation, position the front end of the molding over the forward body panel stud. Position the molding by aligning the other 6 retainers to the body panel studs. Secure the molding working from the front edge to the rear by pressing firmly the molding retainers onto the body panel studs.

Callout

Component Name

Roof Panel Exterior Molding

Procedure

Remove the roof panel exterior molding starting at the rear of the vehicle.
Release the six molding retainers from the body panel.
Upon installation, position the front end of the molding over the forward body panel stud.
Position the molding by aligning the other 6 retainers to the body panel studs.
Secure the molding working from the front edge to the rear by pressing firmly the molding retainers onto the body panel studs.