Front Fender Emblem/Nameplate Replacement (HYBRID 2 MODE)

WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Fender Emblem/Nameplate Replacement (HYBRID 2 MODE)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Fender Nameplate (HYBRID 2 MODE) Procedure CAUTION: Refer to Exterior Trim Emblem Removal Caution . Use a J 25070 or equivalent to remove the old nameplate. When removing protective liners from adhesive backed emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion. Clean all the adhesive residue from the fender using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water. Wipe the surface dry with a clean lint-free towel prior to installing the new emblem. Peel the adhesive tape backing from the nameplate. Position and adhere the nameplate to the fender. Using a clean, dry cotton towel, apply palm pressure to the nameplate to ensure full adhesion is made to the fender. Special Tools: J 25070 Heat Gun 500-700°F

Callout

Component Name

Front Fender Nameplate (HYBRID 2 MODE)

Procedure

CAUTION: Refer to Exterior Trim Emblem Removal Caution .

Use a J 25070 or equivalent to remove the old nameplate.
When removing protective liners from adhesive backed emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
Clean all the adhesive residue from the fender using a 50/50 solution by volume of isopropyl alcohol and clean drinkable water.
Wipe the surface dry with a clean lint-free towel prior to installing the new emblem.
Peel the adhesive tape backing from the nameplate.
Position and adhere the nameplate to the fender.
Using a clean, dry cotton towel, apply palm pressure to the nameplate to ensure full adhesion is made to the fender.

Special Tools:
J 25070 Heat Gun 500-700°F