Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the blower motor resistor to the blower case assembly.
- Install the blower motor resistor screws to the blower case assembly.
Tighten: Tighten the screws to 1 N.m (9 lb in).
- Install the blower motor to the blower case assembly.
- Install the blower motor screws to the blower case assembly.
Tighten: Tighten the screws to 1 N.m (9 lb in).
- Install the HVAC module wire harness from the blower case assembly.
- Install the air inlet assembly. Refer to Air Inlet Assembly Replacement .
- Install the evaporator core. Refer to Evaporator Core Replacement .
NOTE:
Refer to FASTENER NOTICE
.