Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Pedal Assembly, Studs & Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the bolt to the clutch pedal assembly.
Tighten: Tighten the clutch pedal assembly bolt to 10 N.m (89 lb in).

Fig 2: Clutch Pedal Assembly & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the clutch position switch by sliding downward.

Fig 3: Pushrod & Clutch Pedal

Courtesy of GENERAL MOTORS CORP.

Connect the clutch master cylinder pushrod to the clutch pedal assembly.

Fig 4: Clutch Position Switch & Clutch Pedal

Courtesy of GENERAL MOTORS CORP.

Install the clutch position switch to the clutch pedal assembly.

Fig 5: Clutch Pedal Assembly, Studs & Nuts

Courtesy of GENERAL MOTORS CORP.

Install the nuts to the clutch pedal assembly studs.
Tighten: Tighten the clutch pedal assembly nuts to 23 N.m (17 lb ft).