Seat Belt Indicator Circuit Malfunction - Driver
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Seat Belt Indicator Circuit Malfunction - Driver
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Seat Belt Schematics | |||
| 1 | Did you review the Seat Belt System Description and Operation and perform the necessary inspections? | Go to Step 2 | Go to Operational and Functional Checks |
| 2 |
IMPORTANT:
The fasten safety belt indicator should turn ON when the driver seat belt is unbuckled.
|
Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 | Replace the IPC. Refer to Control Module References
for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 8 | - |
| 5 |
|
Go to Step 8 | Go to Step 6 |
| 6 | Test the seat belt switch - left ground circuit for an open or high resistance. Did you find and correct the condition? |
Go to Step 8 | Go to Step 7 |
| 7 | Replace the seat belt switch - LF. Refer to Front Seat Belt Buckle Replacement (Quick Connect) or Front Seat Belt Buckle Replacement (Side Mount) . Did you complete the replacement? |
Go to Step 8 | - |
| 8 | Operate the system in order to verify the repair. Did you find and correct the condition? |
System OK | Go to Step 3 |