Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Position the flywheel to the crankshaft.
- Install the NEW flywheel bolts until snug.
- Have an assistant install the J 38122-A , and a breaker bar to the crankshaft balancer in order to prevent the flywheel from rotating when tightening the flywheel bolts.
- Tighten the flywheel bolts.
Tighten: Tighten the bolts to 53 N.m (39 lb ft) plus an additional 25 degrees using the J 45059 .
- Remove the J 38122-A and breaker bar.
- Install the transaxle. Refer to Transmission Replacement .
NOTE:
Refer to Fastener Notice
.