Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Cylinder Head And Gasket

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: DO NOT use any sealing material.

Install the cylinder head gasket.
Install the cylinder head.
Lightly apply clean engine oil to the threads and the bottom side flange of the head bolts and allow the oil to drain before installing.
Install NEW cylinder head bolts.

NOTE: Refer to Fastener Notice .

Fig 2: Identifying Cylinder Head Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Install and tighten the cylinder head bolts in the sequence shown.
Tighten: Tighten the bolts to 30 N.m (22 lb ft) plus an additional 155 degrees using the J 45059 .

Fig 3: Locating Front Cylinder Head Bolts

Courtesy of GENERAL MOTORS CORP.

Install the NEW front cylinder head bolts.
Tighten: Tighten the bolts to 35 N.m (26 lb ft).
Install the timing chain. Refer to Timing Chain, Sprockets, and/or Tensioner Replacement .

Fig 4: View Of Radiator Inlet Hose To Engine

Courtesy of GENERAL MOTORS CORP.

Install the radiator inlet hose to the cylinder head.
Position the radiator inlet hose clamp using the J 38185 . See Special Tools .

Fig 5: Coolant Recovery Inlet Hose And Clamp

Courtesy of GENERAL MOTORS CORP.

Install the coolant recovery inlet hose (1) to the cylinder head.
Position the coolant recovery inlet hose clamp (2).
Install the exhaust manifold. Refer to Exhaust Manifold Replacement (2.2L (L61) and 2.4L (LAT)) .
Install the intake manifold. Refer to Intake Manifold Replacement .
Fill the cooling system. Refer to Draining and Filling Cooling System (Static Fill) or Draining and Filling Cooling System (GE 47716 Fill) .