LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1575 (Automatic Transmission - 5AT - DTC P0762 To DTC P2770) >> DTC P2769 >> Test Description

Test Description

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  During the TCC enable solenoid valve operation, listen for an audible click. Command the ON and the OFF states. Repeat the commands as necessary.
  2. 3:  This step verifies that the PCM is providing voltage to the TCC enable solenoid valve.
  3. 4:  This step tests for an open in the ground circuit to the TCC enable solenoid valve.
DTC P2769

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Install a scan tool.
  2. Turn ON the ignition with the engine OFF.
    3. IMPORTANT: Before clearing the DTCs, use the scan tool in order to record the Freeze Frame and Failure Records for reference. The Clear Info function will erase the data.
  3. Record the DTC Freeze Frame and Failure Records.
  4. Clear the DTCs.
  5. With a scan tool observe the TCC Enable Sol. CKT Status parameter.
Does the TCC Enable Sol. CKT Status parameter display OK?		 Go to Diagnostic Aids In This Test Go to Step 3 
3 
  1. Turn OFF the ignition.
  2. Disconnect the transmission inline 5-way connector.
  3. With a test lamp connected to a good ground, probe the TCC enable solenoid valve control circuit on the engine side of the inline 5-way connector.
  4. Turn ON the ignition, with the engine OFF.
Does the test lamp illuminate for 1 second?		 Go to Step 4  Go to Step 5 
4  Test the TCC enable solenoid valve high control circuit internal transmission harness for a short to ground. Refer to Testing for Short to Ground .
Did you find a condition?		 Go to Step 8  Go to Step 6 
5 Test the TCC enable solenoid valve high control circuit for a short to ground. Refer to Testing for Short to Ground and Wiring Repairs .
Did you find and correct the condition?		 Go to Step 11  Go to Step 7 
6 Inspect for poor connections at the transmission inline 5-way connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?		 Go to Step 11  Go to Step 9 
7 Inspect for poor connections at the PCM harness connector. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?		 Go to Step 11  Go to Step 10 
8 Replace the transmission internal solenoid harness. Refer to Transmission Wiring Harness Extension Replacement .
Did you complete the repair?		 Go to Step 11  -
9 Replace the TCC enable solenoid valve. Refer to Accumulator Valve Body Assembly Overhaul .
Did you complete the replacement?		 Go to Step 11  -
10
IMPORTANT: Always perform the PCM set up procedure.
  1. Replace the PCM. Refer to Control Module References for replacement, setup, and programming.
  2. Perform the PCM set up procedure.
Did you complete the replacement?		 Go to Step 11  -
11 Perform the following procedure in order to verify the repair:
  1. Select DTC.
  2. Select Clear Info.
  3. Drive the vehicle at normal operating temperature at speeds of 80-120 km/h (50-70 mph) to enable the TCC.
  4. Select Specific DTC.
  5. Enter DTC P2769.

Has the test run and passed?		 Go to Step 12  Go to Step 2 
12 With the scan tool, observe the stored information, capture info. and DTC info.
Does the scan tool display any DTCs that you have not diagnosed?		 Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK
scientia non olet · About LEMON Manuals