LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1573 (Engine Controls And Fuel - 2.2L (L61) - DTC P0700 To DTC P2A01) >> DTC P1640 >> Diagnostic Aids

Diagnostic Aids

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
DTC P1640

Step Action Yes No
Schematic Reference: Engine Controls Schematics
Connector End View Reference: Engine Control Module Connector End Views or Engine Controls Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 Is DTC P0446, P0496, P0560, or P0563 set? Go to Diagnostic Trouble Code (DTC) List - Vehicle Go to Step 3 
3 Observe the General Info - Output Data List with a scan tool.
Do any parameters indicate a fault present?
Go to Step 4  Go to Step 5 
4 Test for a short to voltage on the control circuit of the component that indicated a fault. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?
Go to Step 6  Go to Step 5 
5 Replace the engine control module (ECM). Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?
Go to Step 6  -
6
  1. Clear the DTCs with a scan tool.
  2. Turn OFF the ignition for 30 seconds.
  3. Start the engine.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records.
Does the DTC fail this ignition?
Go to Step 2  Go to Step 7 
7 Observe the Capture Info with a scan tool.
Are there any DTCs that have not been diagnosed?
Go to Diagnostic Trouble Code (DTC) List - Vehicle System OK