LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1563 (Engine Controls And Fuel - 2.4L (Lat) - DTC P0010 To DTC P0354) >> DTC P0030, P0036, P0053, P0054, P0135, or P0141 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the sensor.
  2. Ignition ON, connect a test lamp between the HO2S heater voltage supply circuit terminal D and ground. The lamp should illuminate.
    • If the lamp does not illuminate, test the voltage supply circuit for an open/high resistance or a short to ground.
    • If the circuit tests normal and its fuse is open, replace the HO2S.
  3. Ignition OFF, connect a test lamp between the HO2S low control circuit terminal C and battery voltage. The lamp should not illuminate.
    • If the lamp illuminates, test the low control circuit for a short to ground. If the circuit tests normal, replace the ECM.
  4. Engine running, leave the test lamp connected from the previous step. The lamp should flash or be ON steady.
    • If the test lamp is not on steady or flashing, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the ECM.
    5. IMPORTANT:
    • The output driver should detect a short to volage and turn OFF. If a resistance fault is present, the driver will remain ON and the scan tool will display more than 0.0 amp. Less than 10 ohms of resistance may set a DTC.
    • Performing this test may set additional DTCs.
  5. Ignition OFF, install a 30A fused jumper wire from the heater voltage supply circuit terminal D to the heater control circuit terminal C.
  6. Engine running, observe with a scan tool that the Heater parameter indicates 0.0A.
    • If more than the specified value, test the heater voltage supply and control circuits for resistance greater than 3 ohms. If the circuits test normal, replace the ECM.
  7. If the control module and all circuits test normal, replace the HO2S.
scientia non olet · About LEMON Manuals