Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Element From The Seat Back Pad

Courtesy of GENERAL MOTORS CORP.

Peel off the self-stick paper backing from the heater element.
Position the element on the pad and press firmly to install the element.
Lower the seat back trim cover. Press on the hook and loop retainers to engage the retainers.

Fig 2: Locating Seat Back Cover Hook Retainers

Courtesy of GENERAL MOTORS CORP.

Connect the lower J-hook retainer on the seat back trim cover.
Install the armrest. Refer to Front Seat Armrest Replacement .

Fig 3: Removing/Installing Screws At Seat Back Panel

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Position the seat back panel. Secure the panel with the screws.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 4: View Of Seat Back Frame Bolts

Courtesy of GENERAL MOTORS CORP.

Position the seat back assembly between the fold-flat recliners. Secure with the seat back bolts.
Tighten: Tighten the bolts to 70 N.m (52 lb ft).
Connect the electrical connectors to the seat heater element.
Install the head restraint. Refer to Front Seat Head Restraint Replacement .

Fig 5: Removing/Installing Inboard Recliner Trim Panel

Courtesy of GENERAL MOTORS CORP.

Position the inboard recliner trim panel. Secure with the panel screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).

Fig 6: View Of Front Seat Back Recliner Trim Panel

Courtesy of GENERAL MOTORS CORP.

Position the outboard recliner trim panel. Secure with the panel screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Install the front seat. Refer to Front Seat Replacement - Bucket .