LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1550 (Engine Controls And Fuel - 3.5L (L66) - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Intake Air Temperature (IAT) Sensor 2
    GM1233528Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Make sure the MAP sensor mounting surface is clean. Install the MAP sensor with the new O-ring and attachment bolt (6).

    Tighten:  Tighten the manifold absolute pressure sensor screw to 4 N.m (35 lb in).

  2. Connect the MAP sensor harness connector. Push the connector in until the lock position is felt, then pull back to confirm engagement.