LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1550 (Engine Controls And Fuel - 3.5L (L66) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Hoses/Pipes Replacement - Chassis/Canister >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Hose/Pipe & Retainers At Vehicle Underbody
    GM49888Courtesy of GENERAL MOTORS CORP.
  1. Position the purge pipe to the vehicle.
  2. With the rear of the pipe positioned slightly rearward and down, raise the front of the pipe into position.
  3. Install the remainder of the pipe into position.
  4. Install the purge pipe to the pipe retainers.
  5. Secure the pipe retainers (1) to the vehicle underbody.
    6. Fig 2: View Of Evaporative Emission Canister
    GM1226407Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  6. Install the rear brake hose brackets to the body studs and install the rear brake hose bracket retaining nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  7. Connect the EVAP pipe to the EVAP canister.
  8. Lower the vehicle.
    9. Fig 3: View Of EVAP Purge Pipe
    GM879155Courtesy of GENERAL MOTORS CORP.
  9. Remove the caps or plugs from the purge pipe and the engine purge hose.
  10. Connect the purge pipe to the engine purge hose. Refer to Plastic Collar Quick Connect Fitting Service (Plastic Collar)  or Plastic Collar Quick Connect Fitting Service (Plastic Collar Lever Release)  or Plastic Collar Quick Connect Fitting Service (Plastic Collar Press Release) .
scientia non olet · About LEMON Manuals