Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the EVAP canister vent solenoid valve into the EVAP canister, with the valve aligned to the released position.
- Rotate vent valve clockwise to secure into the locked position.
- Connect the electrical connector to the EVAP canister vent valve.
- Connect the EVAP lines.
- Install the EVAP canister and bolts.
Tighten: Tighten the bolts to 8 N.m (71 lb in).
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
.