Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- A current DTC will clear on the next malfunction-free ignition cycle.
- A history DTC will clear after 100 consecutive malfunction-free ignition cycles.
- Using a scan tool
DTC C0475
| Step | Action | Yes | No |
|---|---|---|---|
| Connector End Views Reference: Power Steering Connector End Views | |||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 | Inspect for poor connections at the electric power steering (EPS) motor harness connector. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 6 | Go to Step 3 |
| 3 | Test the EPS motor control circuits for a short to ground or an open. Refer to Circuit Testing
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 6 | Go to Step 4 |
| 4 | Test the EPS motor control circuits for a short to voltage. Refer to Testing for a Short to Voltage
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 6 | Go to Step 5 |
| 5 | Replace the EPS assembly. Refer to Steering Column Replacement
. Did you complete the repair? |
Go to Step 6 | - |
| 6 |
|
Go to Step 2 | System OK |