Trim Height Measurement

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Trim height is a predetermined measurement relating to vehicle ride height. Incorrect trim heights can cause the vehicle to bottom out over bumps, damage to the suspension components and symptoms similar to wheel alignment problems. Inspect the trim heights when diagnosing suspension concerns and before inspecting the wheel alignment.

Perform the following before measuring the trim heights:

Set the tire pressure to the specifications shown on the certification label. Refer to Vehicle Certification, Tire Place Card, Anti-Theft, and Service Parts ID Label .
Inspect the fuel level. Add additional weight if necessary to simulate a full tank.
Empty the passenger and rear compartments, except tor the spare tire.
Place the vehicle on a flat and level surface, such as an alignment rack.
Verify that all the vehicle doors are securely closed.
Verify that the vehicle hood and rear deck lids are securely closed.
Determine the existence of installed after market accessories or modifications that could affect trim height measurement.

IMPORTANT: All dimensions are measured vertical to the ground. Trim height should be within 22.0 mm (0.87 in) either way to be considered correct.