Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the EVAP vent solenoid by gently turning the solenoid clockwise until it clicks into position.
- Connect the EVAP vent solenoid electrical connector.
- Install the EVAP canister bracket-to-underbody fasteners.
Tighten: Tighten the EVAP canister-to-body nuts to 8 N.m (71 lb in).
- Lower the vehicle from the hoist.
NOTE:
Refer to Fastener Notice
.