Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the EVAP vent solenoid electrical connector.
- Install the EVAP canister-to-body underbody fasteners.
Tighten: Tighten the EVAP canister nuts to 8 N.m (71 lb in).
- Connect the EVAP canister purge and vent lines to the EVAP canister.
- Connect the EVAP canister fresh air line to the fuel tank fresh air line.
- Lower the vehicle from the hoist.
NOTE:
Refer to Fastener Notice
.