LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1545 (Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the CKP sensor O-ring and lubricate with a mineral based grease.
    2. Fig 1: View Of Crankshaft Position (CKP) Sensor
    GM770823Courtesy of GENERAL MOTORS CORP.
  2. Gently insert the CKP sensor into the block.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the CKP sensor bolt to 8 N.m (71 lb in).

  4. Reconnect the CKP sensor electrical connector.
  5. Install the starter. Refer to Starter Motor Replacement (2.2L (L61)) .
  6. Perform the CKP system Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals