LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1541 (Rear Suspension System) >> Repair Instructions >> rear Wheel Bearing and Hub Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Wheel Drive Shaft
    GM933721Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear brake drum. Refer to Brake Drum Replacement .
  2. On vehicles with all-wheel drive, remove the wheel drive shaft spindle nut.
    3. Fig 2: Disconnecting/Connecting Wheel Speed Sensor Electrical Connector
    GM933149Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the wheel speed sensor electrical connector, if equipped.
    4. Fig 3: Wheel Bearing/Hub & Mounting Bolts
    GM931439Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not damage the wheel drive shaft joint seal.
  4. Support the wheel drive shaft with heavy mechanic's wire, or equivalent.
  5. Remove the wheel bearing/hub mounting bolts.
  6. Remove the wheel bearing/hub assembly from the suspension knuckle.
scientia non olet · About LEMON Manuals