LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1541 (Rear Suspension System) >> Repair Instructions >> rear Wheel Bearing and Hub Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wheel Bearing/Hub & Mounting Bolts
    GM931439Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel bearing/hub assembly to the steering knuckle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the wheel bearing/hub mounting bolts.

    Tighten:  Tighten the bolts to 84 N.m (62 lb ft).

    3. Fig 2: View Of Rear Wheel Drive Shaft
    GM933721Courtesy of GENERAL MOTORS CORP.
  3. On all-wheel drive vehicles, install the wheel drive shaft spindle nut.

    Tighten:  Tighten the nut to 110 N.m (81 lb ft).

    4. Fig 3: Disconnecting/Connecting Wheel Speed Sensor Electrical Connector
    GM933149Courtesy of GENERAL MOTORS CORP.
  4. If equipped, route the wheel speed sensor electrical harness through the backing plate and seat the grommet.
  5. Connect the wheel speed sensor electrical connector.
  6. Install the rear brake drum. Refer to Brake Drum Replacement .
scientia non olet · About LEMON Manuals