Removal & Installation (4.8L, 5.3L & 6.0L)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Crankshaft Position (CKP) sensor variation learn procedure will need to be performed whenever CKP sensor is removed or replaced. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION.

Disconnect negative battery cable. Raise and support vehicle. Remove flywheel cover bolt. See Fig 1. Remove starter mounting bolts. Disconnect oil level sensor harness connector. Slide starter forward until starter clears transmission. Disconnect electrical connectors from starter solenoid. Remove starter.
Clean area around Crankshaft Position (CKP) sensor before removal to prevent debris from entering engine. Disconnect CKP sensor harness connector. Remove CKP sensor retaining bolt and CKP sensor.
To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS . Perform CRANKSHAFT POSITION (CKP) SENSOR VARIATION LEARN PROCEDURE in COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION.

Fig 1: Removing Flywheel Cover Bolt (4.8L, 5.3L & 6.0L Engines)

Courtesy of GENERAL MOTORS CORP.

Fig 2: Locating Crankshaft Position Sensor (4.8L, 5.3L & 6.0L)

Courtesy of GENERAL MOTORS CORP.