LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Engine Controls - Removal, Overhaul & Installation) >> Engine Sensors & Switches >> Manifold Absolute Pressure Sensor >> Removal & Installation (8.1L)

Removal & Installation (8.1L)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2002 GMC Yukon XL, 2002 GMC Yukon, 2002 Chevrolet Tahoe, 2002 Chevrolet Suburban, and 2002 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen bolt on intake manifold sight shield at top of engine. Remove intake manifold sight shield from top of engine. Disconnect Manifold Absolute Pressure (MAP) sensor harness connector. See Figure.
  2. Remove MAP sensor retaining bolt and washer. Remove MAP sensor from intake manifold. To install, coat MAP sensor seal with Rubber Lubricant (9985770). DO NOT dip MAP sensor directly into Rubber Lubricant as vacuum port may become blocked. Replace MAP sensor seal as necessary.
  3. To complete installation, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals