LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1537 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Oil Pan Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the oil pan for dents or damage. Dry the oil pan before installation.
    2. Fig 1: Locating Oil Pan Gasket
    GM104471Courtesy of GENERAL MOTORS CORP.
  2. Install the oil pan gasket. Use a new gasket if the sealing ribs are damaged.
    3. Fig 2: View of Oil Pan
    GM104468Courtesy of GENERAL MOTORS CORP.
  3. Install the oil pan. Replace the bottom pan, if damaged.
    4. Fig 3: Identifying Oil Pan Bolts
    GM104466Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the oil pan attaching bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  5. Lower the vehicle.
  6. Fill the transmission.
  7. Inspect the transmission fluid level. Refer to Transmission Fluid Checking
  8. Inspect the oil pan gasket for leaks.
    9. NOTE: Transmission Auxiliary Pump Priming must be performed after any service procedure is performed on the transmission that involves the draining of and refill of transmission fluid. Failure to perform the Transmission Auxiliary Pump Priming will result in damage to the auxiliary pump and possible damage to the transmission.
  9. Using a scan tool, prime the Transmission Auxiliary Pump.
scientia non olet · About LEMON Manuals