Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Install the control valve body to spacer plate gasket (22) onto the spacer plate (23).
- Install the control valve body assembly (18) onto the gasket (22).
- Inspect the transmission fluid pressure (TFP) switch assembly (13) in order to verify the condition and correct location of the 4 pressure switch O-rings.
- If necessary replace the pressure switch O-rings.
- Install the TFP switch assembly (13) onto the control valve body assembly.
- Install the eighteen control valve body assembly bolts.
- Hand start the bolts.
Tighten: Tighten the bolts to 14 N.m (124 lb in).
- Install the transmission side cover. Refer to Case Side Cover Replacement .
- Reset the TAP values. Refer to Transmission Adaptive Functions .
NOTE:
Refer to FASTENER NOTICE
IMPORTANT:
It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.