LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1537 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Oil Cooler Pipes Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Upper Transaxle Oil Cooler Pipes Fitting At Radiator
    GM1471451Courtesy of GENERAL MOTORS CORP.
  1. Install the transaxle oil cooler pipes to the vehicle.
  2. Fasten the transaxle oil cooler pipe retaining clip to the radiator
    3. NOTE: Refer to Fastener Notice .
    IMPORTANT: The correct thread engagement is critical. Crossthreaded fittings can achieve proper tightness value and still leak.
  3. Install the lower transaxle oil cooler pipe fitting to the radiator.

    Tighten:  Tighten the fitting to 16 N.m (12 lb ft).

  4. Install the transaxle oil cooler pipes to the transaxle.
  5. Install the transaxle oil cooler pipe retaining nut.

    Tighten:  Tighten the nut to 4 N.m (27 lb in).

  6. Lower the vehicle.
  7. Install the upper transaxle oil cooler pipe fitting to the radiator.

    Tighten:  Tighten the fitting to 16 N.m (12 lb ft).

  8. Install the battery box. Refer to Battery Tray Replacement (2.2L (L61)) or Battery Tray Replacement (2.4L (LAT)) or Battery Tray Replacement (3.5L (L66)) .
    9. NOTE: Do NOT overfill the transaxle. The overfilling of the transaxle causes foaming, loss of fluid, shift complaints, and possible damage to the transaxle.
  9. Adjust the transmission fluid level. Refer to Transmission Fluid Checking .
  10. Inspect for fluid leaks.
scientia non olet · About LEMON Manuals