LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1537 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Channel Plate and Gasket Removal

Channel Plate and Gasket Removal

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Channel Plate And Gasket
    GM481640Courtesy of GENERAL MOTORS CORP.
  1. Remove the ten channel plate bolts (8 and 25).
    2. NOTE: Pry on the channel plate near locating dowel pins (45) to prevent damage to sealing surfaces.
  2. Remove the channel plate assembly (27). Keep the following components with the channel plate:
    • The drive sprocket to channel plate thrust washer (34)
    • The three accumulator pistons (29)
    • The manual valve (800)
    • The detent lever spring (804) and bolt (805)
  3. Remove and discard the channel plate to case gasket (28).
scientia non olet · About LEMON Manuals