LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Transmission Wiring Harness Extension Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Shift Control Solenoid Valve Electrical Connectors, Transmission Wiring Harness & Bolt
    GM1229877Courtesy of GENERAL MOTORS CORP.
  1. Apply automatic transmission fluid to a new transmission wiring connector O-ring seal.
  2. Install the new transmission wiring connector O-ring seal onto the transmission wiring harness assembly.
  3. Install the transmission wiring harness assembly into the transmission case assembly through the wiring harness bore.
    4. NOTE: Refer to Fastener Notice .
  4. Install the transmission wiring harness assembly bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  5. Install the clutch pressure control solenoid cover. Refer to A/B Clutch Pressure Control Solenoid Assembly Cover Replacement .
scientia non olet · About LEMON Manuals