LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The control cable must be disconnected from the transaxle range switch lever prior to disconnecting it from the control cable bracket. Otherwise damage to the manual shift shaft may result, requiring transaxle disassembly.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the left splash shield. Refer to Engine Splash Shield Replacement .
  4. Remove the range selective lever bolt and cover.
  5. Using the J 36346  , disconnect the control cable from the transaxle range switch lever.
    6. Fig 1: Transaxle Range Switch Lever Nut, Lock Nut, Washer & Lever
    GM1233354Courtesy of GENERAL MOTORS CORP.
  6. Remove the transaxle range switch lever nut (4), lock nut (3), washer (2), and lever (1).
scientia non olet · About LEMON Manuals