LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Reverse Idler Gear Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Reverse Idler Gear Locating Pins, Gear Assembly & Bolts
    GM1542296Courtesy of GENERAL MOTORS CORP.
  1. Install both 10 x 16 mm reverse idler gear locating pins (530) into the transmission case (31).
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the reverse idler gear assembly (533) into the transmission case (31).
    3. IMPORTANT: Overtightening of the idler gear retaining plate bolts will cause the reverse idler gear to bind.
  3. Install both M8 x 1.0 x 35 mm reverse idler gear retaining plate bolts (532).

    Tighten:  Tighten the bolts to 26 N.m (20 lb ft)

scientia non olet · About LEMON Manuals