LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Reverse Idler Gear Replacement >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Positioning Reverse Idler Gear With Shorter Hub Side To Plate
    GM1542295Courtesy of GENERAL MOTORS CORP.
  1. Install the lower reverse idler gear thrust washer (526) on the reverse idler gear retaining plate assembly (531).
  2. Install the 2 reverse idler gear inner bearings (528) on the reverse idler gear retaining plate assembly (531).
    3. IMPORTANT: The shorter hub side of the reverse idler gear installs to the plate as shown.
  3. Install the reverse idler gear (527) on the reverse idler gear retaining plate assembly (531).
  4. Install the upper reverse idler gear thrust washer (526) on the reverse idler gear retaining plate assembly (531).
  5. Install the reverse idler gear retaining ring (525) on the reverse idler gear retaining plate assembly (531).
scientia non olet · About LEMON Manuals