LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Regulator Valve Body Removal

Regulator Valve Body Removal

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Regulator Valve Body Assembly & Bolts
    GM1203378Courtesy of GENERAL MOTORS CORP.
  1. Remove the regulator valve body assembly (430) bolts (411), (412), (413) and (414).
    2. Fig 2: Stator Shaft Stop Pin
    GM1206245Courtesy of GENERAL MOTORS CORP.
  2. Remove the stator shaft stop pin (405).
    3. Fig 3: Regulator Spacer Plate, Locating Pins, Stator Shaft & Torque Arm Assembly
    GM1206241Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2 regulator spacer plate locating pins (401).
  4. Remove the stator shaft and torque arm assembly (431).
    5. IMPORTANT: When the spacer plate (400) is removed the oil cooler check ball return spring (227) and the oil cooler check ball (228) will fall out of the control valve body assembly.
  5. Remove the spacer plate (400).
  6. Remove the stator shaft O-ring seal (406) from the stator shaft (404). Replace the stator shaft O-ring seal when assembling the transmission.
scientia non olet · About LEMON Manuals