LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Main Shaft Rear Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Expanding The Mainshaft Rear Bearing Retaining Ring Using Pliers
    GM1203909Courtesy of GENERAL MOTORS CORP.
  1. Using snap ring pliers, expand the mainshaft rear bearing retaining ring (101) as far as possible to allow the mainshaft rear bearing to pass through the retaining ring.
  2. Using the 78 mm side of the DT 46427  (2), push the mainshaft rear bearing out of the mainshaft rear bearing retaining ring (101). See Special Tools .

    It is not necessary to remove the mainshaft rear bearing retaining ring (101) unless the groove in the transmission case needs cleaning or the retaining ring is damaged.

  3. Inspect the bearing for excessive wear or damage. Replace as needed.
scientia non olet · About LEMON Manuals