LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> Automatic Transmission Fluid Temperature Sensor Installation

Automatic Transmission Fluid Temperature Sensor Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fluid Temperature Sensor, Harness Assembly, O-Ring Seal & Bolts
    GM1363160Courtesy of GENERAL MOTORS CORP.
  1. Install a new 12 mm x 2.4 mm fluid temperature O-ring seal (23) on the fluid temperature sensor (22).
  2. Insert the fluid temperature sensor with harness assembly (22) into the correct transmission case (31) bore hole.
  3. Install the fluid temperature sensor assembly (22).
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the fluid temperature sensor assembly M6 x 1.0 x 18 mm bolt (21).

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  5. Install the connector on the temperature sensor connector bracket (52).
scientia non olet · About LEMON Manuals