LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1536 (Automatic Transmission - 5AT - Introduction (2 Of 2)) >> Repair Instructions >> Repair Instructions - Off Vehicle >> 1st/Coast Clutch Apply Fluid Collar Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Applying Compressed Air Into 1st Clutch Fluid Feed Pipe
    GM1203905Courtesy of GENERAL MOTORS CORP.
  1. Remove the 1st/2nd clutch shaft shim (74) from the transmission case.
  2. Cover the feed pipe opening of the 1st clutch apply fluid collar (76) with a shop rag to prevent oil from squirting out the feed pipe when compressed air is applied in the fluid port.
    3. CAUTION: When you use compressed air in order to clear fluid passages and to dry parts, always aim the air pressure away from face and eyes. Always wear adequate eye protection in order to avoid injury from dirt and debris that may adhere to parts.
  3. Apply compressed air into the 1st clutch fluid feed pipe port located in the transmission case as shown.
  4. Remove the 1st and coast clutch apply fluid collar assembly (76) from the transmission case (31).
scientia non olet · About LEMON Manuals