LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1535 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions >> Front Wheel Drive Shaft Oil Seal Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front wheel and tire assemblies. Refer to Tire and Wheel Removal and Installation .
  3. Remove the wheel driveshaft. Refer to Front Wheel Drive Shaft Replacement (Non Hybrid) or Front Wheel Drive Shaft Replacement (Hybrid) .
  4. Fig 1: Removing Front Wheel Drive Shaft Oil Seal
    GM863208Courtesy of GENERAL MOTORS CORP.
  5. Use the SA9133T  in order to remove the seal.
  6. Inspect the seal bore for nicks or for burrs. Clean the bore with a fine grade sandpaper, if necessary.