LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1535 (Manual Transmission - GETRAG 5 Speed) >> Repair Instructions >> Axle Shaft Oil Seal Replacement (Left) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the seal bore in the housing.
  2. Apply a light bead of Permatex 51531® P/N 21005993 or equivalent on the diameter of the seal that presses into the case bore.
    3. Fig 1: Installing Differential Bearing Race Seal
    GM660201Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Prior to installing the seal, inspect the J 44385  for nicks or burrs that may damage the seal lip. See Special Tools .
  3. Using the J 44385  (2) and the J 7079-2  (1), install the axle seal. See Special Tools . Ensure the seal is lined up with the bore during installation.
  4. Install the wheel driveshaft. Refer to Front Wheel Drive Shaft Replacement (Non Hybrid) or Front Wheel Drive Shaft Replacement (Hybrid) .
  5. Remove the fluid level check plug and verify the fluid is level with the opening.
  6. If the transaxle is not properly filled, add DEXRON®III fluid until it begins to flow out of the fill/check plug.
    7. NOTE: Refer to Fastener Notice .
  7. Install the fluid check plug.

    Tighten:  Tighten the plug to 38 N.m (28 lb ft).

  8. Install the wheel and tire. Refer to Tire and Wheel Removal and Installation .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals