Throttle Body Installation

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Throttle Body

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: The powertrain control module (PCM) must perform the idle learn procedure to determine the minimum throttle position and to establish idle speed when any of the following components are replaced:

Throttle body
Timing belt
Timing belt drive sprocket
Crankshaft and bearings

Refer to Idle Learn .

Install the studs (516), if required.
Tighten: Tighten the studs to 7.8 N.m (69 lb in).
Install the gasket (517) and throttle body (518).
Install the nuts (519) and bolts (555).
Tighten: Tighten the nuts and bolts to 22 N.m (16 lb ft).
Install a NEW O-ring (713).
Install the MAP sensor (712) and bolt (711).
Tighten: Tighten the bolt to 3.4 N.m (30 lb in).
Install the throttle body coolant hoses.