LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1521 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Powertrain Mount Balance - Lower Mount

Powertrain Mount Balance - Lower Mount

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Follow the balance procedure in the order listed in the following steps. Powertrain mounts must be tightened in sequence.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: View Of Front Transaxle Mount Through Bolt
    GM928767Courtesy of GENERAL MOTORS CORP.
  2. Loosen the front mount through bolt. Do not remove.
    3. Fig 2: View Of Transaxle Mount And Mounting Bolts
    GM928736Courtesy of GENERAL MOTORS CORP.
  3. Loosen the rear mount through bolt. Do not remove.
  4. Shake the powertrain vigorously from front to rear and allow the powertrain to settle.
    5. NOTE: Refer to Fastener Notice .
  5. Tighten the rear motor mount through bolt.

    Tighten:  Tighten the bolt to 110 N.m (81 lb ft).

    6. Fig 3: View Of Front Transaxle Mount Through Bolt
    GM928767Courtesy of GENERAL MOTORS CORP.
  6. Tighten the front motor mount through bolt.

    Tighten:  Tighten the bolt to 110 N.m (81 lb ft).

  7. Lower the vehicle.
scientia non olet · About LEMON Manuals