Closing to the Fully Closed Position

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

To close the power sunroof from the following positions:

Open position, push and hold the sunroof switch forward.
Vent position, pull and hold downward the sunroof switch.

Holding the sunroof switch to the closed position will apply the sunroof switch low reference circuit to both the sunroof switch open signal and sunroof switch open vent signal circuits. Holding the sunroof switch to the closed position will cause the sunroof switch open signal and sunroof switch open vent signal circuits (12 volt references) to be pulled to 0 volts. The constant low inputs to the sunroof module indicates a close request. As the close request has been initiated, the sunroof module will drive the motor to the closed position until the limit switch closes, indicating a flush close position. As the sunroof glass nears the closed position, the wind deflector will retract, and the rear sunroof glass will raise slightly, then seats to flush with the roof panel. To close the sunshade, this will have to be manually slid closed.