LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1519 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> Starter Solenoid Clicks, Engine Does Not Crank

Starter Solenoid Clicks, Engine Does Not Crank

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Starter Solenoid Clicks, Engine Does Not Crank

Step Action Yes No
Schematic Reference:  Starting and Charging Schematics  
Connector End View Reference: Master Electrical Component List
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 Turn the ignition to the START position.
Did the starter solenoid click?
Go to Step 3  Go to Starter Solenoid Does Not Click 
3 Inspect the engine and belt drive system for mechanical binding, seized engine, or seized generator.
Does the engine move freely?
Go to Step 4  Go to Engine Will Not Crank - Crankshaft Will Not Rotate for the 2.2L (L61) engine, or Engine Will Not Crank - Crankshaft Will Not Rotate for the 3.5L (L66) engine
4 Test the battery positive cable between the battery and the starter solenoid for high resistance. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?
Go to Step 8  Go to Step 5 
5 Test the ground circuit between the battery and the starter motor for a high resistance. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?
Go to Step 8  Go to Step 6 
6 Inspect for poor connections at the starter. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?
Go to Step 8  Go to Step 7 
7 Replace the starter. Refer to Starter Motor Replacement (2.2L (L61))  or Starter Motor Replacement (2.4L (LAT))  or Starter Motor Replacement (3.5L (L66)) .
Did you complete the replacement?
Go to Step 8  -
8 Operate the system for which the symptom occurred.
Did you correct the condition?
System OK Go to Step 2