Removal Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Using a small flat-bladed tool, remove the fastener cover from the windshield upper garnish molding, by prying at the bottom edge.
- Remove the fastener from the garnish molding.
- Starting at the top, gently pull on the garnish molding to disengage the clips.
- Remove the molding from the vehicle.
CAUTION:
Use care when working around the roof rail inflator module because sharp objects may puncture the roof rail airbag and the airbag will not deploy correctly.
In order to avoid personal injury, if any part of the module is damaged replace the entire module
In order to avoid personal injury, if any part of the module is damaged replace the entire module
NOTE:
If a vehicle is equipped with a head curtain inflator module ensure that the inflator module and tether are undamaged. If tether or curtain airbag are damaged in any way, they must be replaced.