Installation Procedure
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
- Position the trim panel over the top of the door and push downward to engage the trim panel hooks to the door structure.
- Install the screw located at the bottom of the door trim panel
Tighten: Tighten the screw to 2.5 N.m (22 lb in)
- Install the fasteners located behind the pull handle escutcheon.
Tighten: Tighten the screw to 2.5 N.m (22 lb in)
- Snap the escutcheon into place.
- Install the inside door handle. Refer to Door Inside Handle Replacement .
NOTE:
Refer to Fastener Notice
.