LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1505 (Interior Trim And Paneling) >> Repair Instructions >> Center Pillar Upper Garnish Molding Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fastener Cover And Garnish Molding
    GM977195Courtesy of GENERAL MOTORS CORP.
  1. Position the center pillar garnish molding over the lower garnish molding with the bottom tabs behind the lower molding.
  2. Gently push at the clip locations to install the garnish molding.
  3. Insert the weatherstripping over the trim edge.
  4. Install the center pin of the garnish molding fastener.
  5. Install the fastener cover to the garnish molding.
    6. NOTE: Refer to Fastener Notice .
  6. Install the shoulder belt assembly and fasteners.

    Tighten:  Tighten the fasteners to 50 N.m (37 lb ft).

  7. Press on the shoulder belt height adjuster cover until the cover snaps closed.
  8. Ensure proper operation of the seat belt.
scientia non olet · About LEMON Manuals