Inflatable Restraint Passenger Presence System Replacement - Front (with Heated Seat)
WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Inflatable Restraint Passenger Presence System Replacement - Front (with Heated Seat)
| Callout | Component Name |
|---|---|
|
CAUTION:
Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.
CAUTION:
To avoid personal injuries, re-zero the passenger presence system whenever you remove or replace the seat cushion or trim. Failure to do so may cause the system to malfunction.
NOTE:
Refer to Fastener Notice
. Fastener Tightening Specifications:
Refer to Fastener Tightening Specifications .Preliminary Procedure
|
|
| 1 | Cover, Passenger Seat Cushion Refer to Front Seat Cushion Cover and Pad Replacement . |
| 2 | Heater, Seat Cushion Tip: Disconnect the electrical connector. |
| 3 | Sensor, Inflatable Restraint Passenger Presence System Tip:
|
| 4 | Pad, Passenger Seat Cushion |
| 5 | Screw, Inflatable Restraint Passenger Presence Module (Qty: 3) Tighten: 2 N.m (18 lb in) |
| 6 | Module, Inflatable Restraint Passenger Presence Module Tip: Remove module from bracket to replace. Refer to Control Module References for programming and setup information. |