Diagnostic Aids

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.

DTC B0053 will be accompanied by another DTC, other than DTC B1000 and DTC B0051. Repair the malfunction causing the other DTCs before installing a new SDM.

DTC B0053

Step	Action	Yes	No
Schematic Reference: SIR Schematics
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Turn OFF the ignition. Inspect the vehicle for signs of inflator module or pretensioner deployment. Does the vehicle show any signs of inflator module or pretensioner deployment?	Go to Step 4	Go to Step 3
3	Inspect the front of the vehicle and undercarriage for signs of impact/collision. Does the vehicle show any signs of impact/collision?	Go to Step 4	Go to Step 5
4	Install a scan tool. With a scan tool, observe the SIR DTC display. If a history DTC exists, refer to Diagnostic Aids for that specific DTC and diagnose the problem. Replace components and perform inspections as required following an accident. Refer to Repairs and Inspections Required After a Collision . Did you complete the action?	Go to Step 5	-
5	Use the scan tool to attempt to clear DTC B0053. Has DTC B0053 been cleared successfully?	Go to Step 7	Go to Step 6
6	Replace the inflatable restraint sensing and diagnostic module (SDM). Refer to Control Module References for replacement, setup, and programming. Did you complete the replacement?	Go to Step 7	-
7	Reconnect all SIR components. Use the scan tool in order to clear the DTCs. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text. Does the DTC reset?	Go to Step 2	System OK