LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1502 (Seat Hardware, Seat Trim, And Upholstery) >> Repair Instructions >> Front Seat Back Cushion Cover and Cushion Pad Replacement (Non-Fold Flat) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Headrest Guides
    GM981023Courtesy of GENERAL MOTORS CORP.
  1. Position the seat back pad on the frame.
  2. Install the seat back trim cover over the top of the seat back.
  3. Install the head restraint guides by pressing the guides into position until the locking tabs engage.
    4. Fig 2: Locating Seat Back Cover Hook Retainers
    GM866891Courtesy of GENERAL MOTORS CORP.
  4. Continue installing the seat back trim cover, pressing over the hook and loop locations to ensure that the hooks engage.
  5. Connect the J-hook retainer to the seat back trim cover.
  6. Install the head restraint. Refer to Front Seat Head Restraint Replacement .
    7. Fig 3: Disconnecting/Connecting Heat Module Electrical Connector
    GM981887Courtesy of GENERAL MOTORS CORP.
  7. On vehicles with heated seats, connect the electrical connector to the seat heat module.
  8. Install the armrest to the seat. Refer to Front Seat Armrest Replacement .
  9. Install the side trim panel to the seat cushion. Refer to Front Seat Cushion Outer Trim Panel Replacement (2-Way)  or Front Seat Cushion Outer Trim Panel Replacement (4-Way)  or Front Seat Cushion Outer Trim Panel Replacement (6-Way) .
  10. Install the seat into the vehicle. Refer to Front Seat Replacement - Bucket .
scientia non olet · About LEMON Manuals