LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2003 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1500 (Disc Brakes - Rear - S & T Series) >> Overhaul >> Rear Brake Caliper Overhaul >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 1999 Oldsmobile Bravada, 1999 GMC Sonoma, 1999 GMC Jimmy, 1999 GMC Envoy, and 1999 Chevrolet S10 Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new piston seal, the caliper bore, and the piston with clean brake fluid.
  2. Install the piston seal. Make sure the piston seal is not twisted in the caliper bore groove.
  3. Install the boot into the caliper housing bore by hand.
  4. Install the piston in the caliper bore. Push the piston to the bottom of the bore by hand.
  5. Install the boot on the piston.
scientia non olet · About LEMON Manuals